Loading...

Kwik Grip

Kwik Grip is a solvent based polychloroprene contact adhesive. It is suitable for porous and non-porous surfaces.

 

Features

  • Instant bond
  • Heat resistant
  • Flexible
  • Interior and Exterior

Ideal For

  • Porous and non-porous surfaces including vinyl, cork, rubber, leather, canvas, laminated plastics and timber.

 

Buy Now

Kwik Grip
Size 15 ml Tube, 50ml Tube
Colour Yellow
Technology Epoxy
Use Interior

Where can this product be used?

  • Suitable for use on a wide variety of surfaces, its contact bond achieves instant adhesion on a wide range of surfaces

What materials is this product suitable for?

  • Cork
  • Rubber
  • Leather
  • Canvas
  • Laminated plastics*
  • Felt
  • Metals
  • Timber

How To Use

Contact Bond Method:

  1. If cutting material to size, ensure material is slightly oversize all around and trim once bonded.
  2. Using applicator completely cover both surfaces with Kwik Grip and keep apart until adhesive is ‘touch dry’ – approx 20 minutes, no more than 40 minutes.
  3. Carefully position items, keeping apart with dowels. When edges are perfectly aligned, remove dowels and working from one edge press surfaces firmly together. Grabs immediately on contact.
  4. Secure the bond by running a roller over the bonded surfaces or by hammering the surfaces from the centre outwards using a padded block. Maximum strength is reached after 24 hours.


For Wet Bonding: (For small areas or for bonding where on surface is porous)

  1. Use in a well ventilated area. Ensure surfaces to be bonded are clean, dry and free from grease and dirt.
  2. Apply Kwik Grip to one surface, then bring surfaces together and clamp until dry.


Limitations:

  • Do not apply below 10°C.
  • Will not bond to Polypropylene or Polyethylene.
  • *Some plastics such as vinyl sheeting and polystyrene are attacked by Kwik Grip. Test in an inconspicuous area prior to application. Seek advice of vinyl flooring manufacturers prior to use with their products as discoloration and bubbling can occur with some types.
  • Not suitable for bonding rough, ill-fitting surfaces. (Consider the suitability of alternative products such as Liquid Nails for these applications.)

Handy Tips

  • Use in a well ventilated area.
  • Ensure surfaces to be bonded are clean, dry and free from grease and dirt.
  • Strength is dependent on surface area being bonded – the larger the area, the higher the strength.
  • Extremely porous surfaces may require two coats of Kwik Grip on to the porous surface.
  • On non-porous surfaces, ensure Kwik Grip is touch dry to prevent bubbling.

Clean Up

  • Clean up with mineral turpentine while wet.
  • Once dried adhesive is difficult to remove, soaking in lacquer thinners or toluene may help to soften slightly.

Data Sheet

SDS-Kwik Grip

TDS-Kwik Grip